Many homeowners choose the KRMF706ESS KitchenAid refrigerator for its quality and excellent ability to keep food fresh for longer. But like any kitchen appliance, it could be better. The KRMF706ESS refrigerator encounters problems from time to time, and that’s fine.
If your KitchenAid refrigerator has run into a fault and you hope to fix it, you have come to the right place. Here, we delve into the world of this spectacular refrigerator while highlighting common problems and possible solutions that save you time and money. Keep reading.
KRMF706ESS Lights Not Working
One of the common issues with a KRMF706ESS refrigerator is its light stops working. Often, after years of use, the light might go off. Well, there are a couple of reasons why that might happen:
- The door has been open for longer than 10 minutes.
- The light switch is not being triggered
- The wiring harness is loose
- The light socket is loose
- The bulbs are blown
So what’s the solution?
Door Opened for Longer than Ten Minutes
Like most KitchenAid refrigerators, the KRMF706ESS refrigerator turns off the light after leaving the door open for over 10 minutes.
This feature helps save the life of the bulb and your electricity. Hence, you might not have closed the door the last time you opened the fridge. Close the door well for one minute, and this reset the feature.
Note: This feature applies to all the five doors of the KRMF706ESS model. Also, the refrigerator not closing can result from worn-out fridge seals.
Light Switch Not Activating
A switch by the door hinge of the KRMF706ESS switches on or off the refrigerator’s lights. You should change it if your lights aren’t working or blinking. Also, you should note that devices with magnets can also interfere with the light switch. So ensure no electronic devices are nearby.
Replace Wiring Harness
This step usually comes after all the other efforts have proven abortive. You may have changed your light bulbs and the switch and even confirmed that the fridge seals are in a good state; replacing your wiring harness is the next step.
This process can be tedious. So here is a guide to properly remove and replace your KRMF706ESS wiring harness.
Other Possible Solutions
Aside from the ones we have mentioned, there are several other reasons why your KRMF706ESS KitchenAid Refrigerator lights don’t come on:
- Loose light socket
- Blown light bulb (There will be signs like black spots, rattles when you shake it, and pieces of materials outside the bulb.)
- Light Assembly
My Refrigerator is Not Cooling
Refrigerators not cooling is a common issue with several refrigerator brands; undoubtedly, the KRMF706ESS is no exception.
Often, the cause of this issue varies across the spectrum, from as little as dirty condenser coils to faulty condenser door gaskets. That said, here are some of the steps to take when you realize your refrigerator is not cooling:
Clean your Condenser Coils
Condenser coils are under the refrigerator. They help to dissipate heat, which, in turn, leads to the refrigerator’s cooling effect. When the condenser coils pick up dirt, they don’t work effectively anymore, often affecting the refrigerator’s ability to cool. Check the condenser coils for dirt; if you find any, clean them.
Power Outage
On the KRMF706ESS refrigerator, the digital display will show ‘PO.’ The fridge won’t cool unless the error message is rectified. It is a popular reason why the refrigerator refuses to cool.
To fix this, you must press any button to acknowledge the message and then another button to resume the fridge operation. Wait about 30 minutes, and you will see the temperature cool.
The Air Vent is Blocked
When there is a lack of proper airflow, it can hamper the refrigerator cooling system. If your fridge isn’t cooling, a blocked air vent is a likely culprit. Visually check if any item has blocked the vent and move aside anyone you see. After that, you can check if the cooling has been adjusted 30 minutes to 1 hour later.
Other possible solutions
Aside from the ones we have mentioned, there are several other reasons why your KRMF706ESS KitchenAid Refrigerator refuses to cool. But we can’t touch them all. Regardless, here are some parts of the refrigerator that you can check for faults or defects:
- The door opens and closes a lot; it takes time to freeze
- Temperature should be set to medium or high when it should be low
- Hot environment (install next to a heat source or in a clumped-up place)
- Lots of food items in the fridge at once
- Evaporator Fan Motor
- Temperature Control Thermostat
- Defrost Heater Assembly
- Start Capacitor
- New fridge install (takes about 24 hours to cool down)
If all the above are functioning fine, seek professional help or contact KitchenAid.
The Refrigerator Water Dispenser is not WORKING.
KRMF706ESS KitchenAid Refrigerator’s external water dispenser is one of the refrigerator’s many perks. However, for several owners, it stops working well or doesn’t work at all. Here are some likely solutions:
Check if the Water Filter
Often, the water filter hampers the normal flow of water. If tiny particles have clogged it, the water flow might be restricted. You can easily replace the water filter or clean out all the microparticles. Check your KitchenAid KRMF706ESS refrigerator use and care guide on accessing it quickly.
Water Inlet Valve
If the water inlet valve of your KRMF706ESS KitchenAid Refrigerator is defective or the water pressure is low, your dispenser won’t work. If the case is a bad water inlet valve, you might have to replace it. On the other hand, the problem might be low water pressure. Ensure the water pressure is up to 20 PSI so the valve can properly function.
Dispenser Switch
Test the dispenser switch with a multimeter (learn how to use it); replace it if it isn’t working. If the dispenser switch is faulty, it won’t work, so it is crucial to look into it.
Other Possible Solutions
Here are other parts of the refrigerator you can check for defects if your dispenser still doesn’t work after doing the three above:
- Low Water Pressure from House Supply
- Filter Holder
- Micro Switch
- Door Not Fully Closing
- Water Dispenser Control is Locked
If your refrigerator’s dispenser still doesn’t work, check what KitchenAid has to say.
Refrigerator Ice Maker Not Working
Ice maker is one of the many alluring features of the KRMF706ESS KitchenAid Refrigerator. That said, here are the steps you can take to fix your KRMF706ESS KitchenAid Refrigerator’s Ice maker:
Defective Main Control Board
The main control board sends voltage to the refrigerator’s ice maker. If the main control board is faulty, the ice maker won’t work. You can inspect the panel and use a multimeter to determine if the ice maker gets any voltage from the main control board.
Check the Water Inlet Valve
The water inlet valve controls water flow into the dispenser and ice maker. If it is damaged or the water doesn’t have enough pressure, it won’t get to the ice maker so it won’t work. Hence, you want to check the water pressure getting to the valve and if there are any damages.
Replace the Ice Maker Assembly
The ice maker assembly comprises several parts; often, a piece might have developed a fault. With ice maker assembly, you have to change the entire thing. However, before you replace the ice maker assembly, check other components like the water valve, water line, fan, and freezer temperature.
Other Solutions
Suppose the ones above were dead ends; here are other parts of the refrigerator you might want to inspect.
- Fill hose
- Ice level control board
- Door switch
- Water Filter
- Icemaker Fill Tube Heater
More KRMF706ESS KitchenAid Refrigerator Problems and Quick Solutions
While the problems above are typical, we may still need to address the issue with your KRMF706ESS KitchenAid Refrigerator. Here, however, we list even more problems while highlighting parts that might be behind them.
The KRMF706ESS freezer is cold, but the refrigerator is warm
Possible faulty parts:
- Evaporator Fan Motor
- The Evaporator Coils are Frosted Over
- Temperature Control Thermostat
- Door Gasket
- Temperature Control Board
- Defrost Heater Assembly
- Thermistor
- Compressor
- Temperature Sensor
KRMF706ESS Refrigerator leaking water
Possible faulty parts:
- Door Gasket
- Water Tank Assembly
- Water Filter Housing
- Water Inlet Valve
- Water Filter Head
- Water line
- Ice maker assembly
The refrigerator door is not closing properly
Possible faulty parts:
- Door Support
- Door Gasket
- Door Catch
- Door Switch
- Door Hinge
- Door Guide
- Fridge Seals
Parting Thoughts
KRMF706ESS KitchenAid Refrigerator is an incredible kitchen appliance revered for its aesthetic and fantastic functionalities. However, the refrigerator is flexible and will fall to fault occasionally.
With an instructions manual and a DIY mindset, most of the issues need a few tweaks here and there. But if you have checked and checked using our guide to no avail, visit a repair shop and get your refrigerator sorted!